Maintenance - Sartorius YDP30 Mode D'emploi

6. Maintenance

This section presents the clean tools and methods to maintain your printer.
1. Please use one of the following materials to clean the printer.
– Cotton swab (head cleaner pen)
– Lint-free cloth
– Vacuum | blower brush
– 100% ethanol
2. The cleaning process is described as follows:
Item
Head cleaner pen
Printer part Method
Print head
1. Always turn off the printer before
cleaning the print head.
2. Allow the print head to cool for at least
one minute.
3. Use a cotton swab and 100% ethanol to
clean the print head surface.
Platen roller
1. Turn the power off.
2. Rotate the platen roller and wipe it
thoroughly with 100% ethanol and a
cotton swab, or lint-free cloth.
Tear bar | peel bar
Use the lint-free cloth with 100% ethanol to
wipe it.
Sensor
Compressed air or vacuum
Exterior
Wipe it with a water-dampened cloth
Interior
Brush or vacuum
– Do not touch the printer head with your hand. If you inadvertently touch it, please use
ethanol to clean it.
– Please use 100% ethanol. DO NOT use medical alcohol which might damage the printer
head.
– In order to maintain the printer's performance and extend the printer's service life,
regularly clean the print head and supply sensors when you change to a new media.
Print head
Maintenance
Print head
Item
Interval
Clean the print head when
changing a new label roll
Clean the platen roller when
changing a new label roll
As needed
Monthly
As needed
As needed
Operating Instructions YDP30 15