Honeywell VisionPRO IAQ Guide D'installation page 7

VisionPRO ® IAQ
Installer setup
Setup functions
0502 Furnace filter
alert options
0510 Humidifier pad
change alert
0520 UV lamp change
alert
0530 Adaptive Intelligent
Recovery ™
0540 Program periods
0570 Non-compressor
off time (min.)
0580 Compressor off
time (min.)
0600 Heat temperature
range stop
0610 Cool temperature
range stop
0620 Non-compressor
on time (min.)
0630 Compressor on
time (min.)
0640 Clock format
0650 Extended fan
timer (heat)
0660 Extended fan
timer (cool)
0670 Keypad lock
0680 Heat temperature
control
0690 Cool temperature
control
(English: Page 4 • Français: Page 10 • Español: Página 16)
Settings & Options
0 Timer counts Heat & Cool run time
1 Timer counts Cool run time only
E Auto Discover
0 Off
1 90 calendar days (about 30 days run time)
2 180 calendar days (about 60 days run time)
3 365 calendar days (about 90 days run time)
E Auto Discover
0 Off
1 365 calendar days (1 year)
2 730 calendar days (2 years)
1 On **
0 Off
4 4 program periods (Wake, Leave, Return, Sleep)
2 2 program periods (Wake, Sleep)
0 Off
[Other options: 1 to 5 minutes]
5 5 minute compressor off time
[Other options: 0 to 4 minutes]
90 Max. heat temperature setting is 90°F (32°C)
[Other options: 40 to 90°F (4°C to 32°C)]
60 Min. cool temperature setting is 60°F (15°C)
[Other options: 60-99°F (15°C to 37°C)]
0 Off
[Other options: 1 to 15 minutes]
0 Off
[Other options: 1 to 15 minutes]
12 12-hour time (i.e., "3:30 pm")
24 24-hour time (i.e., "15:30")
0 Off
[Other options: Fan runs for 30, 60, 90 or 120 seconds after
call for heating ends]
0 Off
[Other options: Fan runs for 30, 60, 90 or 120 seconds after
call for cooling ends]
0 Keypad unlocked (fully functional)
1 Partially locked (access to temperature settings only)
2 Fully locked
2 Standard temperature control (recommended)
1 Choose if room is warmer than set temperature
3 Choose if room does not reach set temperature
2 Standard temperature control (recommended)
1 Choose if room is cooler than set temperature
3 Choose if room does not reach set temperature
(factory default in bold)
**
**
7
**
** See page 8