Part Identification; Machine Identification; Machine Positioning And Stability - resto italia TECNO A KUBE 1 Mode D'emploi

3.4. PART IDENTIFICATION

Components of the machine (Fig. 3.4.1, 3.4.2):
1. Refractory stone
2. Door
3. Door glass
4. Control panel
5. Double control panel
6. Identification plate

3.5. MACHINE IDENTIFICATION

The serial number and the data for the machine identification are punched on a plate (see Fig. 2.2.) fixed on the machine base (6).
In the possible requests for technical assistance or in the orders of the spare parts, always indicate the serial number
of the machine plus the model.

3.6. MACHINE POSITIONING AND STABILITY

Ensure that the bearing plane is suitable to support the loads indicated in the Table 2.7.
Position the machine respecting carefully the indications in the Fig. 3.6., as they indicate the min. distances necessary for the operator
or the technician to carry out carefully each sequence of work and/or maintenance.
The stability of the machine foreseen in the conditions of operation allows the use without risks of overturning or falls, so the machine
does not need fixing to the work bench.
ELECTRIC OVEN
1
2
3
Fig. 3.4.1. - Components of the machine (Mod. KUBE 1)
4
1
2
3
5
Fig. 3.4.2. - Components of the machine (Mod. KUBE 2 - KUBE 2 Plus)
KUBE 1
3
KUBE2
KUBE 2 PLUS
33
0.0
6
6