Metabo TNS 150 W Notice D'emploi page 9

Machine Components
Note: There are some constructive differences between
the dry/wet grinding machines.The handling,
described below, is in principle the same with all
machines.
3
2
4
1
1 ON/OFF Switch
2 Tool rest
3 Wet grinding wheel
4 Power cable with plug
5 Indicator for direction of rotation (sticker)
6 Spark protection assembly
7 Grinding wheel, right
8 Tool rest
Machine Installation
The grinding machine should be firmly mounted in a
suitable location. For mounting on a firm and flat base 4
holes are provided in the machine's base. The height
should be chosen so that the tool rest is at about elbow
height. Ensure a power outlet is available at a distance
of approx. 100 - 150 cm.
The machine must be installed in such a way that it is
easily accessible from both the front and the left side.
2
Pedestal support base
Installation of Spark Extinction Glass
For packaging reasons the protective glass and the spark
extinction holder are loosely enclosed and must still be
assembled. See the diagram below for instructions on
how to assemble these components.
5
7
1
stock-no. 090 000 1134
6
8
3
3
A adjusting guard plate
B hexagon head bolt M 4 x 55
C lock washer
D hexagon nut M 4
E spark glass guard
F slotted screws
G disk
H hexagon head screw M 5 x 20
Setting of Tool Rest and Adjusting Protective
Plate
The dry grinding wheel tool supporting mechanism and
the adjusting protective plate must be set in such a way
that the gap between the grinding wheel and the tool
holder or between the grinding wheel and the adjusting
protective plate does not exceed 2 mm.
3
4
1 Grinding wheel
2 Tool rest
3 Spark arrester bracket
9
D
C
F
A
G
H
D
C
F
A
B
1
2
E
E