Troubleshooting - Zanussi ZFU27400WA Notice D'utilisation

Activate the Fast Freeze function for some
hours so that it can reach the sufficient storing
temperature as soon as possible.

Troubleshooting

Warning! Before troubleshooting,
disconnect the mains plug from the mains
socket.
Problem
The appliance does not
operate. The Pilot light
does not flash.
The Pilot light flashes.
The Alarm light flashes.
The compressor operates
continually.
The temperature in the
freezer is too low.
The temperature in the
freezer is too high.
www.zanussi.com
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The appliance is not working prop-
erly.
The temperature in the freezer is
too high.
The temperature is not set correct-
ly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too
high.
The room temperature is too high.
The temperature regulator is not
set correctly.
The Fast Freeze function is switch-
ed on.
The temperature regulator is not
set correctly.
Caution! Never use sharp metal tools to
scrape off frost from the evaporator as
you could damage it. Do not use a mechanical
device or any artificial means to speed up the
thawing process other than those
recommended by the manufacturer. A
temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.
Only a qualified electrician or competent
person must do the troubleshooting that is not
in this manual.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Contact a qualified electrician.
Refer to "Excessive Temperature
Alarm"
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature before
storage.
Decrease the room temperature.
Set a higher temperature.
Refer to" Fast Freeze function".
Set a lower temperature.
Solution
21