Troubleshooting - Zanussi ZFX31400WA Manuel D'utilisation

Troubleshooting

WARNING! Refer to Safety chapters.
What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
The compressor operates con-
tinuously.
There is too much frost and ice.
The temperature in the appliance
is too low/too high
30
Possible cause
The appliance is switched off.
The mains plug is not conected
to the mains socket correctly.
There is no voltage in the mains
socket.
The appliance is not supported
properly.
Temperature is set incorrectly.
Many food products to be
frozen were put in at the same
time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The door is not closed correctly
or the gasket is deformed/dirty.
The water drainage plug is not
correctly positioned.
Food products are not wrapped
properly.
Temperature is set incorrectly.
The temperature regulator is
not set correctly.
The food products' temperature
is too high.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
There is no cold air circulation
in the appliance.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products better.
Refer to "Operation" chapter.
Set a higher/lower tempera-
ture.
Let the food products tem-
perature decrease to room
temperature before storage.
Defrost the appliance.
Open the door only if neces-
sary.
Make sure that there is cold air
circulation in the appliance.
www.zanussi.com