Troubleshooting - Zanussi ZFT11114WA Notice D'utilisation

WARNING!
If the cabinet will be kept on, ask
somebody to check it once in a
while to prevent the food inside from
spoiling in case of a power failure.

Troubleshooting

WARNING!
Refer to Safety chapters.
What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
The compressor operates contin-
ually.
There is too much frost and ice.
Door is misaligned or interferes
with ventilation grill.
The temperature in the appliance
is too low/too high.
www.zanussi.com
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
There is no voltage in the mains
socket.
The appliance is not supported
properly.
Temperature is set incorrectly.
Many food products to be frozen
were put in at the same time.
The room temperature is too
high.
Food products placed in the ap-
pliance were too warm.
The door is not closed correctly.
The door is not closed correctly
or the gasket is deformed/dirty.
The water drainage plug is not
correctly positioned.
Food products are not wrapped
properly.
Temperature is set incorrectly.
The appliance is not levelled.
The temperature regulator is not
set correctly.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket. Con-
tact a qualified electrician.
Check if the appliance stands
stable.
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Refer to "Closing the door".
Position the water drainage plug
in the correct way.
Wrap the food products better.
Refer to "Operation" chapter.
Refer to "Levelling".
Set a higher/lower temperature.
19