Yamaha NS-IC400 Mode D'emploi page 8

INSTALLATION
7
En
Loosen
6
Pull the speaker cable out of the
hole which you have cut.
• Leave some extra length of cable when
pulling the cable out.
7
Connect the speaker cable to the
speaker.
• For detailed instructions, refer to page
9 "CONNECTING YOUR AMPLIFIER/
RECEIVER".
8
Place the speaker into the ceiling.
CAUTION
• When installing the speaker, do not
touch the drive unit directly. This may
cause a malfunction.
• Make sure that mounting clamps are
turned inward when installing the
speaker in a ceiling.
9
Insert the speaker into the hole.
Loosen three screws
approximately one turn counter-
clockwise. It will allow the clamps
to open easily.
Evenly tighten each of the three
mounting screws clockwise using a
Philips screwdriver. (At this time,
these three mounting clamps open
in the ceiling. These opened
clamps will press the ceiling board
and the speaker together to secure
the speaker.)