After Connecting; Painting The Speaker Grille; Specifications - Yamaha NS-IC400 Mode D'emploi

After connecting

• Lower the power amplifier/receiver volume control before changing input sources.
Never change input sources (for example, FM to CD) at high listening levels.
R A
Always turn the receiver/amplifier unit off when installing or removing any cables.
• Anytime you note distortion, reduce the volume control on your power amplifier/
receiver to a lower setting. Never allow your power amplifier to be driven into
"clipping".

PAINTING THE SPEAKER GRILLE

The speaker grilles can be painted to match your room décor. Use high quality
spray paint and select a well ventilated area before proceeding.

SPECIFICATIONS

Type
Driver Full range
Frequency response
Impedance
Nominal Input
Maximum input
Sensitivity
Dimensions (with grille)
Weight (with grille)
* Specifications subject to change without notice due to product improvements.
* Speaker cables are not included with this model.
CONNECTING YOUR AMPLIFIER/RECEIVER
1
2
3
4
5
Full range open back type
10 cm (4") cone type
95 Hz to 40 kHz (-10dB)
8 ohms
30 W
90 W
85 dB / 2.83 V, 1 m
150 86.5D mm ( 5-7/8"
0.8 kg (1.76 lbs)
Carefully remove the grille from the
speaker if attached.
Remove the scrim cloth that is
attached to the back of the grille.
(The adhesive that holds the cloth
in place is reusable.)
Apply the paint to the grille.
• Make sure that the grille holes remain
free of paint.
• Clogging the holes with paint may
diminish the sound quality.
When the paint has fully dried, re-
attach the scrim cloth to the back
of the grille.
Re-install the grille on the speaker.
NS-IC400
3-3/8"D)
10
En