Things That Must Be Done Before Calling Authorized Service; Technical Data - Ugur HSC300N Mode D'emploi

UPRIGHT FREEZER SHOWCASE
Original Instructions
t
HSC300N
NOTE
Pay attention to the following considerations if you do not use your product for reasons such as vacation, trip etc.
If you do not use it for a short time: Leave your product in operating state.
If you do not use it for long time and want to shut it down:
1. Consume the foodstuff inside your product and empty it.
2. Unplug the power cord from the outlet.
3. Apply defrost and internal cleaning steps as described in this manual.
4. Dry the inside of the product thoroughly. Darkening may occur in the product which is not dried.
5. Leave the product door open.
6. THINGS THAT MUST BE DONE BEFORE CALLING AUTHORISED
SERVICE
Troubleshooting
The failures and solutions stated in this section can be performed easily by yourselves, always consult an authorised service provider if these suggestions do
not solve your problem.
CAUTION!
• Intervention to any failure that may occur in your product must be carried out by an authorised service provider.
• Any intervention that may be done by you may harm you, your employee or customer, invalidate the product guarantee and cause material damage (fire
etc.).
• In case of any failure, consult the the seller or authorised service provider.
Problem
Appliance is not working a. The mains plug is not connected.
(no sound or only fan sound b. Thermostat could be defective.
is hearable). c. The fuse may be out of its seat or broken down.
Device internal temperature a. External ambient temperature is very high.
is high. b. Appliance is placed too close to the back wall.
c. Ventilation shutters are obstructed or its front is
d. It may have been exposed to excessive
e. Condenser lamellas are very dirty.
Device internal temperature a. External ambient temperature is very low.
is very low. b. Cooling unit is iced.
High degree of sweating a. External ambient humidity is high.
on the glass and inside the b. Improper seals.
device. c. Often door opening.
Lighting is not working a. Lighting is switched off, switch is in position 0.
One lamp is not working b. The lamp is defect or the starter is defect.
LCD no display a. incorrect battery type.
b. incorrect polarity.
c. empty batteries.
Setting the thermostat values other than the factory settings are completely under the user's responsibility.
Our company shall NOT be held responsible for the material and moral losses that may arise in connection thereto.

7. TECHNICAL DATA

Operating voltage 230 V~, 50 Hz
Power consumption 725 W
Size 595 x 640 x 1840 mm
Net weight 84.2 kg
Class Class 4
WARNING!
The appliance is heavy and should be lifted by two people.
NOTE
Energy consumption test standard in commercial type products is EN23953-2.
Technical specifications of the products are stated on the labels of the product.
Seller reserves the right to change technical specifications of the products without any notice.
(IM)961-000669_HSC300N_GB&DE_IM_V5_161121.indd 11
Possible reason
prevented.
external wind.
a. Insert the mains plug properly.
b. Consult an authorised service provider or a competent electrician.
c. Consult an authorised service provider or a competent electrician.
a. Move the appliance to a place where the external temperature is lower.
b. Ensure there is a space of min. 15 cm from the appliance to the back wall
(Picture 6).
c. Ensure that no shutters are obstructed and good ventilation is given.
d. Place the appliance to another place to protect it from external wind.
e. Consult an authorised service provider or a competent electrician.
a. Place the appliance to another place with higher ambient temperature.
b. Follow the defrost instruction to defrost your appliance.
a. Raise temperature setting.
b. Check gaskets and door sealing.
c. Reduce door opening duration.
a. Switch on lighting to switch position.
b. Consult an authorised service provider to exchange the defect part.
a. replace it with correct battery type (2 x LR44).
b. take out the batteries and replace them again in correct polarity/position.
c. replace with new batteries.
- 11 -
Solution
11/21/16 2:21 PM