Cleaning, Maintenance And Transportation Of Your Product - Ugur HSC300N Mode D'emploi

UPRIGHT FREEZER SHOWCASE
Original Instructions
t
HSC300N
Defrosting
1. If there is excessive frost deposit on the shelves of your device, this will lead decrease in the cooling capacity and increase in energy consumption.
2. If the frost deposit and its thickness are high, place the products inside of your device to another suitable environment that prevents them to get spoiled.
3. Unplug your product. Frost deposit generally melts in two (2) hours.
4. Place a container at water discharge for preventing the melted ice waters to damage the floor.
5. After defrosting operation, wipe internal walls with a dry cloth to make sure that they are not wet.
6. Run your device empty again for three (3) hours and wait for it to cool down. Then you can place your foodstuff in it.
Shutting down your product
1. Transfer the foodstuff inside your product to a convenient place.
2. Unplug your product. (Picture 16)
3. If your product will not be used for a long time, apply following considerations;
Clean your product. Otherwise the humidity on the wall may cause darkening of the internal surface.
PICTURE 16
CAUTION!
• Do not cover it with plastic sheets. Plastic will cause smell and sweating of your product as it does not breathe. Corrosion may be seen as the result of
sweating.
• Smell formation may occur in cases where you fail to store your product with the door open.
How to lock the door
• Use the key provided with the unit.
• Insert the key and turn LEFT to lock the door.
• Turn RIGHT to unlock the door.
5. CLEANING, MAINTENANCE AND TRANSPORTATION OF YOUR
PRODUCT
CLEANING
Cleaning of your device is composed of two stages, which are the internal cleaning and external cleaning.
Following warnings must certainly be abided before start cleaning.
CAUTION!
• Unplug your product before every cleaning.
• Never use domestic cleaning agents, abrasive and scratching substances (surface cleaners, detergent, flammable and sparkling detergents, solvent like
gasoline, thinner, and acid) as cleaning agents. Otherwise loosening may occur in the plastic parts of your product.
• Never use flowing and pressurised water for cleaning.
Internal cleaning
1. Transfer the foodstuff inside your product to a convenient place.
2. Before the internal cleaning, wait until the temperatures of the internal parts of your product reaches to the ambient temperature.
3. Perform cleaning with a soft cotton cloth and warm soapy water.
4. Dry with a dry cotton cloth. Products, which are not dried, may darken in time.
5. Make sure that no wet or humid area is left in the internal section after cleaning.
6. You can reload your product three (3) hours after running your product as stated in this manual.
External cleaning
1. Clean with a cotton cloth and warm soapy water.
2. Prevent penetration of cleaning water into the front control panel and lighting section while cleaning.
3. Clean the door gasket by using clean soapy water only.
Maintenance
This product does not require periodical maintenance.
Transportation
1. Unplug your product from the grounded outlet.
2. Carry out defrost operation.
3. Carry your product at normal using position. Do not carry horizontally, vertically, tilted or with the door open.
4. Protect your product from the impacts while carrying. Do not carry your product when it is plugged in or full.
5. In order not to cause any accident or for preventing the product to get damaged by falling or sliding, secure your product to the vehicle during the
transportation.
(IM)961-000669_HSC300N_GB&DE_IM_V5_161121.indd 10
- 10 -
11/21/16 2:21 PM