Ugur HSC300N Mode D'emploi page 3

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
UPRIGHT FREEZER SHOWCASE
Original Instructions
t
HSC300N
WARNING!
In order to use your product efficiently and safely, please read this
manual entirely before starting using your product and keep it as a
source of reference.
Do not place your product to a place exposed to direct sunlight or
influence area of the heat sources such as stoves, ovens, cookers,
radiant and infrared heaters. Otherwise, this may cause performance
decrease, damage to your product or make it become dysfunctional.
(Picture 1)
Your product is set for operating at mains power of 230 Volt, 50 Hz.
Using your product with a different voltage may cause it become
dysfunctional and fire. (Picture 2)
Our company is not responsible for the failures and material damages
that may occur in case of using without grounding.
Electrical installation must conform to national regulations.
There must absolutely be a residual current relay and a fuse in your
electrical installation for preventing the risks of electrical shock and fire.
Place the device in a damp-free place with unobstructed air circulation.
You must clean the inside of the product before the first use.
After placing your device to its place, wait for one (1) hour without
moving it before using it.
If your device is installed under very cold weather conditions, then the
waiting period must be at least two (2) hours before starting to operate
it.
In case of prolonged blackouts, do not open the door of your product in
order to avoid temperature increase.
If you do not use your device or leave it empty for a short time, do not
unplug it for saving energy. Otherwise, more energy will be consumed
for re-cooling your product.
In products which doors are left open or opened and closed
continuously, frost deposit will increase and no cooling operation will
be carried out. Thus open the door of your product only when needed.
Make sure that the door is closed if not required.
Unplug your product in case of sudden blackouts. For starting again,
plug in your product 20 minutes after the electricity is supplied. High
voltage occurring at the moment of electricity supply may cause
damage to your product and fire.
Your device does not have any sterilizing effect on the microorganisms.
Therefore it is necessary that the foodstuff you place into your product
must conform to the hygiene standards and be packaged. Otherwise,
microorganisms reproducing in foodstuff may pose a threat to your
health.
(IM)961-000669_HSC300N_GB&DE_IM_V5_161121.indd 2
- 2 -
11/21/16 2:21 PM

Publicité

Table des Matières
loading

Table des Matières