Remote Controller Lc-3; Safety Notes; Applications - IMG STAGELINE LED-640RGBW Mode D'emploi

1.2 Remote controller LC-3

The remote controller is available as an accessory
and not supplied with the light effect unit.
18 Button STAND BY to switch the light on and off
19 Button FUNCTION to select different options
depending on the operating mode selected with
the button MODE (
20 Button MODE to switch between
stroboscope mode (LED does not light up)
program selection mode (LED lights up)
colour selection mode (LED flashes slowly)
speed selection mode (LED flashes quickly)
Note: For control via the remote controller no DMX signal
must be present at the input DMX INPUT (12).

2 Safety Notes

This unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING
The unit uses dangerous mains volt-
age. Leave servicing to skilled per-
sonnel only. Inexpert handling of the
unit may result in electric shock.
Please observe the following items in any case:
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity and heat (admissible ambient tempera-
ture range 0 – 40 °C).
G
Do not place any vessels filled with liquid, e. g. a
drinking glass, on the unit.
G
Do not operate the unit and immediately discon-
nect the mains plug from the socket
1. if the unit or the mains cable is visibly dam-
aged,
2. if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the unit must be repaired by skilled
personnel.
G
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the plug.
G
For cleaning the housing only use a dry, soft
cloth; never use water or chemicals. For cleaning
the lenses, you may also use a commercial glass
cleaner.
G
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is not
safely installed, not correctly connected or oper-
ated, or if it is not repaired in an expert way.
chapter 5.5)
.
G
Important for U. K. Customers!
The wires in this mains lead are coloured in ac -
cord ance with the following code:
green/yellow = earth
blue = neutral
brown = live
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
1. The wire which is coloured green and yellow
must be connected to the terminal in the plug
which is marked with the letter E or by the earth
symbol , or coloured green or green and yel-
low.
2. The wire which is coloured blue must be con-
nected to the terminal which is marked with the
letter N or coloured black.
3. The wire which is coloured brown must be con-
nected to the terminal which is marked with the
letter L or coloured red.
Warning – This appliance must be earthed.
If the unit is to be put out of operation
definitively, take it to a local recycling plant
for a disposal which will not be harmful to
the environment.

3 Applications

This unit serves for effect illumination, e. g. on
stage, in discotheques or festival rooms. It creates
white, red, green and blue light dots which are
arranged in five square fields to the shape of a
cross. As a light source, 320 extra bright LEDs are
used which have a low power consumption, a low
heat development and a long life compared to
incandescent lamps and gas discharge lamps.
The light effect unit can be operated via the
remote controller LC-3 or LC-9RTX available as an
accessory or via a DMX controller (4 DMX control
channels). However, also operation without con-
troller is possible, either for individual operation or
interconnected with several LED-640RGBW in the
master/slave mode. The integrated microphone
provides effects in sync with the music.
GB
13