Sabo 92-13H Mode D'emploi page 92

eng 14
When moving from one area to another, put the lever in a position between
«SLOW» and «FAST» When cutting, go to the «FAST» position.
3. Brake pedal
On hydrostatic drive models this pedal is solely for braking and works on the rear
wheels.
4. Parking brake lever
This lever is to stop the lawn-tractor from moving when it has been parked, and
must always be engaged before leaving the machine. The brake is engaged by
fully pressing the pedal (3) and moving the lever to position «A». When you take
your foot off the pedal it will be blocked by the lever in the down position.
To disengage the parking brake, press the pedal again so that the lever returns to
position «B».
5. Drive engagement pedal
This pedal engages drive in the wheels as well as modulating the lawn-tractor's
forward and reverse speeds.
The pedal automatically goes into neutral «N» when released.
To engage forward drive just press it in the «F» direction with your toe-cap, noting
that increasing the pressure on the pedal progressively increases the speed of
the lawn-tractor.
Similarly, reverse is engaged by pressing the pedal with the heel, in the «R»
direction.
ATTENTION!
!
stopped.
6. Key ignition switch
This key operated control has three positions:
«OFF»
«ON»
«START»
automatically return to «ON» from this position.
7. Light switch (if fitted)
For turning on the lights when the key (6) is in the «ON» position.
8. Pilot lamp and signal
This light comes on when the key (6) is in the «ON» position and remains con-
stantly lit while the machine is operating.
Reverse must only be engaged when the lawn-tractor is
means everything is switched off
activates all parts
engages the starter motor. On being released, the key will
COMMANDS AND CONTROL INSTRUMENTS