Sabo 92-13H Mode D'emploi page 89

UNPACKING AND ASSEMBLY
ASSEMBLY OF SUPPORTS FOR GRASS-CATCHER
Fit the two supports (1) and (2) on the
rear plate, using the supplied screws (3),
washers (4) and nuts (5), exactly following
the sequence shown.
First of all position the screws in the cen-
tre of the slots (6) without fully tightening,
and then hook on the grass-catcher to the
supports, checking that there is an even
spacing of 6 to 8 mm between the two
plastic covers - this makes it possible for
the grass-catcher to rotate properly when
being emptied, but still prevents grass cuttings from escaping.
To get the correct spacing, adjust the position of the fastenings or the supports in
relation to the slots (6), then fully tighten the screws (3).
FITTING THE GRASS-CATCHER
First of all assemble the frame, joining the upper part (1), including the opening,
12
14
13
1 2
3
12
1
13 -14
4
R
3 2
1
6 ÷ 8 mm
10
5
6
4
3
4
3
2
4
9
8
6
5
L
2
6
11 10
11
eng 11
3
6
5
4 5
6
4 - 5