Sabo 92-13H Mode D'emploi page 109

MAINTENANCE
NOTE
from cutting, the front part should always be 5 -
6 mm lower than the rear.
– Put the machine onto a flat surface and check
the tyre pressures;
– put 26 mm blocks (1) under the front edge of
the deck and 32 mm blocks (2) under the rear
edge, and then put the lifting lever into position
«1»;
– fully loosen the adjuster (3), the nuts (4 – 6 –
8) and the locknuts (5 – 7 – 9) of the three
trace rods until the deck is resting on the
blocks;
– screw the two upper right nuts (6 – 8) and the
lower left nut (4) until the deck starts rising;
tighten the three locknuts (5 – 7 – 9) and turn
the adjuster (3) until the control cable is taut.
Any difference in height from the ground
between the right and left side of the deck can
be compensated by turning the two nuts (4 – 8)
and locknuts (5 – 9) of just the back rods.
Move the control lever to 2 or 3 different positions, making sure that the deck
rises evenly and that the difference in height from the ground remains the same
between the front and rear edge.
If the front part rises too early or too late, you can regulate the movement by turn-
ing the nuts (10) on the connecting rod (11).
Screwing the nuts on the rod makes the rear part rise earlier, while unscrewing
them does the opposite.
Always remember to fully tighten all the nuts and locknuts when the adjustment
has been made.
If you are unable to get the cutting deck parallel, consult your Dealer.
Brake adjustment
If the brakes should seem to be weak, immediately seek advice from your Dealer.
For achieving good results
1 - h = 26 mm
9
5
8
4
11
6
7
eng 31
2 - h = 32 mm
3
10