Worx WX128 Notice Originale page 13

Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
CHUCK ADJUSTMENT
WARNING: Always lock off trigger switch and
disconnect tool from power source when changing
accessories. Always ensure the bit is secure before
starting the tool. Damage to the Chuck or a loose bit may
cause possible personal injury.
Removing the bits
Inserting the bits
OPERATION
FORWARD/REVERSE ROTATION
CONTROL
WARNING: Never change the
direction of rotation when the
chuck is rotating, wait until it has
stopped!
TWO-SPEED GEAR CONTROL
TORQUE ADJUSTMENT
SCREWDRIVING, DRILLING
OPERATING THE ON/OFF SWITCH
WARNING: Do not operate
for long periods at low speed
because excess heat will be produced
internally.
See Fig. A1
LED LIGHT INDICATOR (9)
Before operation, the LED light will be
See Fig. A2
activated when the On/Off switch is
slightly pressed, and will automatically
See Fig. A3
turn off 20 seconds after the On/Off switch
is released.
The tool and battery are equipped with a
protection system. When the LED Light
is quickly flashing 3 seconds and turn
off, the system will automatically cut off
power to the tool to extend battery life.
The tool will automatically stop during
operation if the tool and/or battery
are placed under one of the following
See Fig. B1
conditions:
• Overloaded: The tool is operated
See Fig. B2
in a manner that causes it to draw an
abnormally high current. In this situation,
release the Trigger Switch on the tool
and stop the application that caused the
tool to become overloaded. Then pull the
See Fig.
Trigger Switch again to restart.
C1,C2,C3
• Overheated: Under the condition
above, if the tool does not start, the
Tool and Battery are overheated. In this
situation, let the Tool and Battery cool
See Fig. D
before pulling the Trigger Switch again.
• Low battery voltage: The remaining
See Fig. E
Battery capacity is too low and the tool
will not operate. In this situation, remove
and recharge the Battery.
WARNING: To turn on the light,
See Fig. F
press the On/Off switch and make
sure the Forward/Reverse Rotation
Control is on right/left position.
EN EN
See Fig. F
13 13