Connecting Up; Basic Connections - Pioneer HTS-570 Mode D'emploi

Connecting up

Chapter 2
Connecting up

Basic connections

Important
• When connecting this system or changing connections, be sure to switch power off and disconnect the power
cord from the wall socket.
After completing all connections, connect the power cord to the wall socket.
Receiver subwoofer
MCACC
SETUP MIC
SPEAKERS
SYSTEM CONNECTOR CONTROL
R
OUT SUBWOOFER SURROUND
USE ONLY WITH DISPLAY UNIT.
SEE INSTRUCTION MANUAL.
R
CENTER FRONT
AC IN
1 Fasten the spacers to the display unit and connect.
If the display unit is difficult to view, the spacers can be
attached to allow changing of the viewing angle. Peel off
the protective paper from the spacers and press the
spacers onto the depressions on the bottom of the display
unit.
Plug the L-shaped end of the display cable into the
connector on the rear of the display unit, then plug the
other end of the display cable into SYSTEM CONNECTOR
jack on the receiver subwoofer.
FM UNBAL 75 AM LOOP ANTENNA
AUDIO INPUT
CONTROL IN
DIGITAL ANALOG
DVD DTV PC/GAME
AUX 1
L (COAXIAL) (OPTICAL) (OPTICAL)
L
R
L
FM antenna
3
Display unit
AM loop antenna
2
Display cable
02
11
En