Using Magicspeed - Dometic MS880 Instructions De Montage Et De Service

MS880
15

Using MagicSpeed

MagicSpeed is controlled using the buttons on the control lever.
15.1 Using the cruise control
ON/OFF button
➤ Press the ON/OFF button once briefly (< 1 sec) to switch on the cruise control.
✓ You will hear two low-pitched signals.
✓ The LED on the control element lights up.
➤ Press the ON/OFF button again to switch the cruise control off.
✓ The LED on the control element goes out.
SET button
Use the SET button to save a preferred speed in the cruise control.
➤ Press the SET button and let go again immediately to set the speed you are
currently driving.
This set speed is maintained until:
– you apply the brake or clutch pedal,
– you switch off the device with the ON/OFF button,
– the vehicle slows down to below the lower activation speed,
– the speed drops by more than 25 % on a slope.
➤ Press the SET button continuously to accelerate the vehicle.
When you let go of the SET button, the cruise control records the current speed
and saves it.
RES button
Press the RES button to recall the last saved speed when:
• you have switched on the cruise control using the ON/OFF button,
• you do not apply the brake or clutch pedal,
• you do not switch off the ignition in the meantime,
• the vehicle does not slow down to below the lower activation speed,
• the current speed is not less than 50 % of the saved value.
➤ Press the RES button and let go again immediately to recall the last saved speed.
EN
Using MagicSpeed
39