Dometic MS880 Instructions De Montage Et De Service page 19

MS880
Orange
A
NOTICE!
Make sure the ignition is switched off. Otherwise a fuse may blow.
➤ Connect the orange cable to a connected positive terminal (terminal 15).
➤ Use a voltmeter to check whether the selected positive terminal carries the full
operating voltage of 12 V and that the orange cable carries no voltage when the
ignition is off.
This test is usually done at the fuse box.
A
NOTICE!
Do not connect the orange cable to the voltage supply for the vehicle
accessories (ACC).
Green
➤ Insulate the green cable.
This cable is not needed. The required earth signal is taken from the accelerator
cable set.
Green/white and violet
I
NOTE
With a CAN bus connection, these cables are only connected when
there is no clutch signal on the CAN bus in your vehicle. See also the
information in the vehicle-specific product overview at
www.dometic.eu/ms880.
Alternatively, you can connect the purple cable with:
• a clutch switch
• the control lamp for the activated parking brake
• (automatic transmission only): the control lamp for park or neutral
You can connect the clutch switch supplied or the vehicle's original clutch switch (if
available) to the green/white and purple cable.
Using the clutch switch supplied
➤ Install the clutch switch as described in chapter "Installing the clutch switch" on
page 17.
EN
Connecting the electrical power to MagicSpeed
19