Dometic FlyTec FT100 Instructions De Montage Et De Service page 20

Installing the flyscreen
5.3 Pre-installing the rails
Cassette profile, skirting board and upper guide rail
The cassette profile, skirting board and upper guide rail must be assembled
lying on the ground (fig. 3, page 4) before being placed in the vehicle.
➤ Check whether the cover profile can be inserted between the C pillar and
interior fittings. You may need to adapt the contour by trimming.
➤ Guide the lower slider of the handle strip along with the cassette profile
into the skirting board.
➤ Pull the cassette and handle strip apart by a bit and then slide the cassette
profile onto the nose on the skirting board.
➤ Secure the cassette profile with the screw (M5 x 30 mm) and M5 nut on
the upper guide rail.
➤ Insert the cover for the C pillar into the cassette so that the drill holes are
located one above the other and secure the two components with three
blind rivets (4 x 8 mm with stainless steel mandrel) without riveting them.
➤ Have two people carefully lift the preassembled flyscreen and position it
in the vehicle.
Adapting the upper guide rail and cover profile for the C pillar
➤ Check whether the contour and position of the upper guide rail fit the ve-
hicle (see enlarged inset in fig. 5, page 5). You may need to adjust the
upper guide rail by cutting the two upper legs.
20
Dometic FlyTec FT100
EN