Hkoenig MXK32 Manuel D'utilisation page 7

7. Turning the knob to required speed (P—pulse, grade 1 to 5 means speed of blades from
low to high).
8. During working mode, the blue light around the knob is on.
Speed adjust:
P—pulse –Stainless steel blade operate with transitorily highest speed, suitable for ice.
1—Stainless steel blade operate with low speed.
2—Stainless steel blade operate with higher speed than grade 1 but lower speed than grade 3.
3—Stainless steel blade operate with higher speed than grade 2 but lower speed than grade 4.
4—Stainless steel blade operate with higher speed than grade 3 but lower speed than grade 5.
5—Stainless steel blade operate with higher speed than grade 4 and it is the highest speed of
the machine.
0—turn off the unit.
Caution:
1. Over-filled can block the operation, please turn off the unit and do not connect the plug, take out
some of material, then operating.
2. Do not use unit continuous more than 2 minutes.
CLEANING AND STORAGE
l In addition to this, you must refer to the security
precautions.
l Do not clean Motor main body, power cord and plug
with water.
l Clean the engine base with a soft, wet piece of cloth
and some mild cleaning agent.
l Fill the jug half-full with hot water and a little cleaning
agent. Let the unit run on speed 2 until the jug is clean.
l The jar base bottom with the blades can be taken apart.
Screw off the base bootm counter-clockwise which is
marked "un-lock" on the bottom. Take out the blades
together with sealing ring facing upwards.
l Now clean jug, cover, closure, base and blades with
sealing ring with hot water and some cleaning agent.