Hkoenig MXK32 Manuel D'utilisation page 6

PARTS ITEM
INSTALLATION
1. Clean the measuring cup, cover and jar (except main body) and so on before first using.
2. To make sure the unit is turned off and not to connect before installation.
3. First ring the jar sealed ring into blade base, then enclose the blade base into jar, last rock
the jar slightly causing it to lock into place.
4. Fit the blender glass jar onto the main body, and turn it slightly in a clockwise so it locks
with the motor section. Fill the jug with the desired foods. Please ensure the water not
spill over from cup. (Maximal water capacity cannot exceed 1500 ml) DO NOT USE THE
UNIT WITHOUT ANY MATERIAL INSIDE.
5. Put the cover on top of the jar and push it down. Insert the closure into the cover and turn
till it locks into place.
Place the measuring cup on the center of cover, anticlockwise rock the measuring cup
6.
slightly.
OPERATION
1. Connect the power.
2. This unit have safety design, it do not work if the jar is not install on main body properly.
3. Turn the turning knob P/0/1/2/3/4/5 to position 0 in order to make sure the unit is turned
off.
4. Fill the jug with the desired foods
5. Put the cover on top of the jar and fix it. Place the measuring cup on the center of cover,
anticlockwise rock the measuring cup slightly.
6. Put the blender glass jar onto the main body, and turn it slightly in a clockwise so it locks
with the motor base.and the machine was fully assembled.