Philips EasySpeed Plus Cordless GC2078 Série Mode D'emploi page 8

ENGLISH
10
Calc-Clean function
IMPORTANT: To prolong the lifetime of your appliance and
to maintain good steaming performance, use the Calc-Clean
function once every two weeks. If the water in your area is
very hard (i.e. when flakes come out of the soleplate during
ironing), use the Calc-Clean function more frequently.
Make sure the steam control is set to
1
Fill the water tank to the MAX indication. (Fig. 3)
2
Do not pour vinegar or other descaling agents into the water tank.
Set the temperature dial to MAX. (Fig. 13)
3
Plug in the base, put the iron on the base and let the iron heat up.
4
(Fig. 6)
Remove the iron when the light ring turns steady blue. (Fig. 8)
5
Hold the iron over the sink. Push the steam control to the Calc-
6
Clean position and hold it. (Fig. 14)
Gently shake the iron while holding the steam control until all
7
water in the water tank has been used up. (Fig. 15)
Caution: While scale is flushed out, steam and boiling water also come
out of the soleplate.
Set the steam control back to
8
Note: Repeat the Calc-Clean process if the water that comes out of the iron
still contains scale particles.
After the Calc-Clean process
Put the iron on the base. Let the iron heat up to dry the soleplate.
1
Take the iron from the base when the light ring turns steady blue.
2
. (Fig. 2)
. (Fig. 2)