Swing-In/Out Footrest Adjustment; Elevating Legrest Adjustment - Zippie ZM-310 Mode D'emploi

Z I PP IE Z M- 310
I. SWING-IN/OUT FOOTREST ADJUSTMENT
Footplate Height Adjustment
a. Remove the hardware(A) from the hanger frame tube.
b. Move the footrest extension tube(B) up or down to set the correct height, and line up
the adjusted holes.
c. Insert the hardware to hold the tube in place.
d. Re-tighten all hardware(A)
2. Battery installation
• See section X. (Batteries) for installation
J. ANGLE ADJUSTABLE CENTER MOUNT HEIGHT ADJUSTMENT
(ASAP Seating only)
1. Quick Independent angle adjustment
a. Depress the button(C) and angle adjust the footplates as an assembly or independant-
ly of each other.
2. Footplate Height Adjustment
a. Loosen the securing screws (D).
b. You can move the footplates up or down to the desired height as an assembly or
adjust the height for each footplate independantly
c. Tighten the hardware(D)
K. ELEVATING LEGREST ADJUSTMENT(Optional)
1. Footplate Height Adjustment
a. To raise footrest, loosen the two bolts(E) that hold the extension tube and footplate
in place.
b. Adjust the footplate up or down for best adjustment, and tighten the hardware(E).
2. Calf pad Adjustment
a. Remove the securing screw (F).
b. Move Calf Pads to desired height.
c. Re-tighten the screws (F) through adjusted hole.
54
55
56
31
XI. DEALER SERVICE & ADJUSTMENT
54
55
56
F
E
127899 Rev. A