Panasonic TY-WK5P1SW Instructions De Montage page 7

5. Attaching and securing the display unit
to the wall-hanging bracket
1. Using the positioning stickers adhered to the wall as guidelines,
align the top of the display unit at the left and right.
2. Engage the insulation spacers at the top of the display unit with
the cutouts at the top of the bracket unit, and slowly lower them
into place.
3. While lifting the display unit slightly, insert the bottom insulation
spacers into the holes at the lower end of the wall-hanging
bracket, and then pull the display unit straight down into place.
CAUTION
• If the plasma TV is lifted too much, its top part will become disengaged
from the wall-hanging bracket.
4. Tighten up the long bolt for securing the unit , which was
secured loosely in step 5 of section 3, until it will go no further.
Note
• Tightening up the long bolt for securing the unit  or the screw for
securing the unit  too much may cause the bracket to be bent out of
shape.
5. Lift the display unit slightly, and check that it is firmly secured in
place.
6. Connect the HDMI cable to the tuner unit.
How to remove the plasma TV from the
wall-hanging bracket
1. Place a soft blanket or piece of cloth underneath the plasma TV unit.
Remove the long bolt for securing the unit  or the screw for
securing the unit  which is attached to the side of the wall-hanging
bracket.
Note
• Otherwise, the long bolt for securing the unit  or the screw for
securing the unit  may drop down by mistake, leaving marks on the
surface of the floor.
2. Disconnect the wires connecting the plasma TV to the other units.
3. While lifting the bottom part of the plasma TV, pull the plasma TV
toward you.
4. Once the insulation spacers at the bottom have been released, lift
the plasma TV straight up.
5. Ensure that the plasma TV unit, which has now been removed from
the wall-hanging bracket, is kept upright while it is being handled so
that no load will be applied to its front or back panel.
Cutout at top
Insulation spacer at top
2.
Insulation spacer at bottom
4. Long bolt for securing the unit 
Long bolt for
securing the
unit 
Insulation spacer at the
Blanket or piece
of cloth
Floor surface
Hole at
bottom
3.
4.
3.
bottom
7