aarke Carbonator II Manuel D'utilisation page 5

User guide
ATTACHING THE GAS CYLINDER
Remove the spill tray grid and then carefully lay the carbonator down on the side with the lever
upwards.
Unscrew the plastic sealing from the cylinder top. Carefully insert the gas cylinder through
the hole at the bottom. Don't drop the cylinder into the hole. When you feel that it reaches the
bottom, begin screwing the cylinder clockwise until it is fastened. Don't screw too hard since this
might break the threads holding the gas cylinder in place.
When you need to replace the gas cylinder, lay the carbonator down on the side with the lever
pointing up and unscrew it counterclockwise and then carefully pull it out of the compartment.
1
English
2
1
EN
2