Troubleshooting Guide - aarke Carbonator II Manuel D'utilisation

User guide

TROUBLESHOOTING GUIDE

Problem:
1. There comes no gas or too little gas
when pushing down the lever.
2. Gas is flowing into the bottle when
pushing down the lever, but the water is
not getting carbonated.
3. There is a leaking sound when pushing
down the lever and very little gas is flowing
into the water bottle.
4. There are drops of water inside the
cylinder compartment
EN
5. Gas starts leaking out when screwing
the cylinder into the machine, even though
the lever is not being pushed down.
6. Cylinder freezes inside the machine
when in use.
Suggested solutions
- Check that the cylinder is not empty
- Try screwing the cylinder a little harder and try
again. Some old cylinders requires this.
- Make sure you are pushing the lever all the way
down (without forcing it)
- If you hear a leaking sound from the machine
when you push down the lever, please check under
problem 3.
- If nothing of this helped, please write an email to
support@aarke.com and describe your problem.
- Make sure you are holding the lever down until you
hear a buzz from the valve. Then release it. Don't
release it before you hear the buzz sound. If this
doesn't help you, please write an email to
support@aarke.com and describe your problem.
- Try screwing the cylinder a bit harder
- It may be something wrong with the cylinder
gasket. Please see instructions for trouble shooting
and replacing the gasket below.
- Try screwing the cylinder a bit harder.
- It may be something wrong with the cylinder
gasket. Please see instructions for trouble shooting
and replacing the gasket below.
- There may be something wrong with the cylinder
gasket. Please see instructions for trouble shooting
and replacing the rubber gasket below.
- It may be due to a leak between the cylinder and
the machine. Try screwing the cylinder a bit harder.
- It may be something wrong with the cylinder
gasket. Please see instructions for trouble shooting
and replacing the rubber gasket below.
English