Names And Functions Of Parts; Front - Tascam iXR Mode D'emploi

Names and functions of parts

Front

1 SIG indicators
The SIG indicators light green when a signal of
at least −32 dBFS is input through the IN 1/IN
2 jacks.
2 PEAK indicators
The PEAK indicators light red when a signal that
is about to distort (−1 dBFS or higher) is input
through the IN 1/IN 2 jacks.
3 GAIN knobs
Use to adjust the input levels of the IN 1/IN 2
jacks.
4 +48V indicator
This indicator lights when the PHANTOM switch
is set to +48V.
5 MONITOR knob
Use to adjust the balance between the signals
input through the unit's input jacks and the
output of the device connected by USB.
6 LINE OUT knob
Use to adjust the output level of the LINE OUT
1/L-2/R jacks.
7 PHONES knob
Use to adjust the PHONES jack output level.
CAUTION
Before connecting headphones, use the PHONES
knob to minimize the volume. Failure to do so
could result in a sudden loud noise that could
harm hearing, for example.
8 USB indicator
This lights when the USB connection is active.
This blinks when the USB connection is inactive.
It is unlit when the unit is off.
6
TASCAM iXR
9 PHONES jack
Connect stereo headphones to this stereo mini
(3.5mm) jack.
The same signal is output from the LINE OUT 1/L
and 2/R jacks.
Use an adapter to connect headphones with a
standard (6.3mm) plug.
0 IN 1/IN 2 connectors
These are combo XLR/TRS input jacks.
Use the MIC/LINE INST switches on the front of
the unit to enable balanced line (MIC/LINE) or
unbalanced (INST) input for the TRS jacks.
q MIC/LINE INST switches
Set according to the IN 1/IN 2 jack input
sources.
Set to MIC/LINE when connecting electronic
instruments, audio devices, mics and similar
equipment. Set to INST when connecting an
electric guitar, electric bass or other equipment
with high output impedance.