DeWalt D26410 Traduction De La Notice D'instructions Originale page 27

Fitting Sanding Discs (fi g. B)
The tool uses 6" (150 mm) hook and loop sanding
discs with a 6 hole dust extraction pattern.
1. Place the tool on a table, sanding pad (5) up.
2 . Place the sanding disc directly on top of the
sanding pad.
3 . Hold the sanding pad (5) with one hand and
align the dust extraction holes (9).
Adjusting the Front Handle (fi g. C)
The position of the front handle can be adjusted for
optimum control.
1. Loosen the knob (10) located in the centre of the
front grip (4).
2. Take the handle from the tool and place it on
either mounting position.
3 . Make sure that the handle is placed correctly.
4 . Tighten the knob.
Adjusting the Orbital Travel (fi g. D)
The orbital travel can be adjusted to the
following settings:
3 mm for finishing applications
6 mm for coarse sanding applications
1. Press the lock button (6).
2. Turn the sanding pad (5) counter-clockwise until
the orbital travel locks in position.
3. Turn the sanding pad a half turn further until the
pad clicks into the required setting.
4 . Release the lock button.
Setting the Electronic
Speed Control Dial (fi g. A)
The speed is infinitely variable from 4,000 -
10,000 min using the electronic speed control
-1
dial (3).
1 . Turn the electronic speed control dial to the
required level. The correct setting, however, is a
matter of experience.
2 . Generally, harder materials require a higher
setting.
Dust Extraction (fi g. E)
WARNING: Since woodworking with a
sander produces dust, always install a
dustbag designed in compliance with
the applicable directives regarding dust
emission.
WARNING: Do not use a dustbag or
vacuum extractor without proper spark
protection when sanding metal.
1. Fit the dustbag (8) into the frame (7) as shown.
2. Attach the frame (7) to the dust extraction
outlet (11).
3. Turn the assembly clockwise to lock it in position.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING:
• Make sure all materials to be sanded
are well secured.
• Apply only a gentle pressure to the
workpiece. Excessive pressure does
not improve the sanding effect, but
only results in an increased load on
the machine and causes the abrasive
to tear.
• Avoid overloading.
WARNING: Do not sand magnesium!
Proper Hand Position (fi g. G)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the front
handle (4), with the other hand on the main handle
(16).
Switching On and Off (fi g. A)
Switching on: press the on/off switch (1).
For continuous operation, also press the lock-on
button (2).
Switching off: press the on/off switch again.
EN GL IS H
25