Direct Healthcare Group SystemRoMedic Bure Rise & Go Manuel D'utilisation page 9

4. Using Bure Walker with Gait training Kit 56-388 - KIT
The walking training harness is an accessory used for increased safety
when walking in the product Bure Rise & Go. The product's both
straps and fastening hooks minimize risks if users suffer from dizziness
or similar issues.
Step 1: Applying the Gait training kit on the patient
The walking training harness is to be used together with Belt MULTI in
various sizes. The Gait training kit contains 4 parts made of soft mate-
rials: 2 straps with soft padding and 2 straps with fastening hooks.
• Straps with padding are to be applied between the patient's legs
and locked in the intended lock.
• Straps with fastening hook hangs loose until patient is secured in
Bure Rise & Go (see later step 3)
Step 2: Secure attachment modules to the Bure Rise & Go Double
• The attachment modules (2 pcs) is pushed in from the inside on the
left and right sides of the armrests under the cushions. We recom-
mend that the modules are placed in the middle of the armrests.
• Lock the module with the supplied screw. Make sure that the
module is secured.
Step 3: Securing a patient in Bure Rise & Go Double
If there is a need to further secure the patient, hook the carabiner
hooks on the green bands (right and left side) in the fastening module.
Tighten the fastening strap so that it is as short as possible.
Pre-caution:
• Green strap is threaded through the buckles from the inside / lower
part (A) - up through the buckle & upper part (B).
• Loose straps must be outside the tensioned strap during use
I F U
B
A
9