AEG FMI 5508 Mode D'emploi page 23

WARNING:
During the dry massage the device may only be opera-
ted in the „1" position.
Wet massage
In order to enjoy a wet massage, fi ll the device with
warm water.
Footbath
• Place the appliance on the fl oor so that you can sit
comfortably in front of it.
• Fill the device with cold or warm water. Do not fi ll
past the maximum mark (see inner wall (MAX), below
the massage knobs). Make sure that the mains plug is
not inserted before you fi ll the device.
• Only connect the machine to a properly installed
safety socket, 230 V/50 Hz.
• Sit down and put your feet in the appliance.
• Set the mode of operation.In order to do so please
turn the switch to the following settings:
• 0 Off
• 1 Heat fi eld + massage + heat
• 2 Heat fi eld + massage + heat + bubble
• 3 Heat + bubble
• Enjoy a deep, penetrating massage by moving your
feet backwards and forwards over the refl ex zone
knobs.
• You can also use the massage rollers supplied. Attach
the rollers in the recesses/holes provided on the
bottom. Please ensure that they lock into place. The
rollers can be removed for cleaning. Grip the roller
with your thumb and index fi nger and pull it out.
Heat fi eld function
Turn the multiple contact switch to level 1 or 2.
Place one foot on the central console. Exert more or less
pressure as you please. You should also move the sole of
your foot massage burls next to the heat fi eld.
After use
• After use, switch the device to 0 (Off ) and remove
the mains plug.
• Tip the device forwards and pour the water through
the aperture.
Never pour water over the function selector switch.
NOTE:
The purpose of the heat generated by the appliance
is not exclusively for the warming of the water. It is
generated to avoid its rapid cooling.
05-FMI 5508 AEG.indd 23 05-FMI 5508 AEG.indd 23
Cleaning
• Before cleaning remove the plug from the socket.
• The spray water protection device can be pulled up in
order to facilitate cleaning. In order to do so, move
your fi ngers along the edges of the spray water pro-
tection device (splash guard) and release the catches.
Then replace the splash guard.
• Never immerse the device in water in order to clean
it.
• Se a moist cloth to clean the appliance.
• Do not use rough or abrasive detergents.
• Dry the appliance with a dry cloth.
Technical Data
Model: ..................................................................................FMI 5508
Power supply: ............................................................. 230 V, 50 Hz
Power consumption:...............................................................90 W
Protection class: .............................................................................. ΙΙ
Net weight: ............................................................................1,64 kg
This device has been tested according to all relevant cur-
rent CE guidelines, such as electromagnetic compatibility
and low voltage directives, and has been constructed in
accordance with the latest safety regulations.
Subject to technical changes without prior notice!
Meaning of the "Dustbin" Symbol
Protect our environment: do not dispose of electrical
equipment in the domestic waste.
Please return any electrical equipment that you will no
longer use to the collection points provided for their
disposal.
This helps avoid the potential eff ects of incorrect dispo-
sal on the environment and human health.
This will contribute to the recycling and other forms of
reutilisation of electrical and electronic equipment.
Information concerning where the equipment can be
disposed of can be obtained from your local authority.
English
23
08.08.2008 14:52:15 Uhr 08.08.2008 14:52:15 Uhr