Warranty And Service; Troubleshooting - Arbortech AS170 Manuel D'instruction

The values state here only indicates the
loudness emitted by this machine. Whether the
operator is required to wear hearing protection
can not be determined here. This depends on
how much noise reaches the operator's ear.
Even though it may not be explicitly required, it
is in your own interest to always wear hearing
protection when operating this machine.

10. WARRANTY AND SERVICE

For warranty repair, inspection, service and spare
parts, please contact your place of purchase,
or
Check out our website www.arbortech.com.au to
locate a dealer or service agent in your area
Disposal
The machine, accessories and packaging should
be sorted for environmental-friendly recycling.
Only for EC countries: Do not dispose of power
tools into household waste! According the European
Guideline 2002/96/EC for Waste Electrical and
Electronic Equipment and its implementation into
national right, power tools that are no longer usable
must be collected separately and disposed of in an
environmentally correct manner.
ITEM SYMPTOM
1 Motor overheating
Declaration of Conformity
We declare under our sole responsibility that the
product AS170 Brick and Mortar Saw described
under "Specifications" is in conformity with the
following standards or standardization documents:
EN 60745 according to the provisions of the
Machinery Directive 2006/42/EC
Technical file at:
Arbortech PTY LTD
67 Westchester Road
Malaga, WA 6090
__________________
Kevin Inkster
Chairman
Arbortech Pty Ltd
Arbortech PTY LTD
67 Westchester Road
Malaga, WA 6090

11. TROUBLESHOOTING

This fault diagnosis is intended for use by persons
familiar with mechanical devices, and provides a
basic capability to maintain the tool. To correct the
user serviceable faults, refer to the Maintenance
section of this manual. The more complex repairs as
noted below, must be performed by an authorised
service centre.
CHECK/REMEDY
• Verify that all cooling vents are not obstructed by operators hand, debris
in vents, or other. Remedy or clean as required.
• Verify blades are not rubbing against each other with excessive force,
either at cutting edge or close to blade mounts.
• Blades may be worn and overheating. Replace as required.
• Check that belt tension is not excessive.
• Check that bearings have not failed by removing plastic side cover and
belt and rotating both pulleys independently checking for roughness. The
power pulley should rotate easily and smoothly. The driven pulley should
rotate smoothly but will have a "springy" feel, wanting to stay in either of 2
positions.
• Verify that the motor housing is secure with the tool. If loose, refer to
authorised service centre immediately.
__________________
Sven Blicks
General Manager
Arbortech Pty Ltd
ENGLISH 12
E
N
G