Motor - Arbortech AS170 Manuel D'instruction

Fig.10
E
N
G
"Hammering!"
Fig.11
"Hammering!"
Fig.12
When using the Mortar Plunge blades, the cut
should have enough clearance on each end
(shown in fig:12), to ensure that no hammering of
the blade ends occurs (as shown in fig.13).
ENGLISH 9
Clearance
each end
Fig.13
"Hammering!"
7. MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn the tool off and disconnect tool from the
power source before making any adjustments or
removing/installing attachments or accessories.
Before reconnecting the tool, depress and release
the trigger switch to ensure that the tool is turned
off.
To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including
brush inspection and replacement) should be
performed by an ARBORTECH authorised service
center. Always use identical replacement parts.

7.1 Motor

Cleaning
CAUTION: Blowing dust and grit out of the motor
and switch actuator using clean, dry compressed
air is a necessary regular maintenance procedure.
Dust and grit particles often accumulate on interior
surfaces and can cause premature failure. Not
regularly cleaning the AS170 will affect the tools
warranty.
CAUTION: ALWAYS WEAR SAFETY GLASSES
when using or cleaning this tool.
Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. Use a
clean, dry cloth only.
Lubrication
ARBORTECH tools are properly lubricated at the
factory and are ready for use.
Accessories