Kemper FK-5 Instructions De Montage page 3

EN
Installation and usage
Prior to commencing installation or
usage read instructions carefully and
follow all directions! Pass these instruc-
tions on to the system operator and
retain for later reference!
Installation and mainte-
Warning!
nance is to be done only by competent
and qualified professionals qualified for
sanitary plumbing. Electrical installation
is to be done only by professionals
qualified for electrical facilities!
Local standard and rules for
Warning!
sanitary plumbing as well as accident
prevention must be adhered to as a
matter of priority.
It is essential that following
Note!
the installation a leak test of the
water-bearing components as well as
a functional test is carried out.
To isolate from
Danger!
mains disconnect the mains
plug prior commencing any
maintenance work.
Safety instructions for installation, maintenance and operation
Usage
The FK-5 Rainwater Utilisation Unit is
intended exclusively as an accessory
to supplement the KEMPER FK-5 Break
Tank Station for rain water utilisation.
Each other usage is considered contrary
to the designated use.
Warning information
Please read and follow the warning
information in these instructions.
Disregard of the warning information
may lead to injury or material damage!
Labelling of important warning information:
Electricity! Indicates
Danger!
hazards that might result in
severe or fatal injury.
Indicates hazards
Warning!
that may lead to injury, material
damage or contamination of
drinking water.
Note! Indicates hazards that
may lead to damages to the
system or malfunctions.
© www.kemper-olpe.de – 10.2018 / K410036900023-00 – 3 / 32
Important notes
for the system operator
Medium: Water
Max. ambient temperature 39°C,
Min. ambient temperature 2°C,
Max. temperature of the inflowing medium 35 °C,
Min. temperature of the inflowing medium 1 °C,
Minimum flow pressure DN 20 = 1 bar / 0.1 MPa,
Minimum flow pressure DN 25 = 1.5 bar / 0.15 MPa,
Max. flow pressure 20 / 25 4.0 bar / 0.4 MPa,
pressure stage PN 10,
Outlet pump pressure
DN 20: 4.3 bar / 0.43 MPa
DN 25: 5.9 bar / 0.59 MPa
1.
Only use the device
- in sound condition
- as intended
Any water
Warning!
withdrawn must under no
circumstances be used as
drinking water - even in
small amounts!
Warranty
Warranty is voided through:
- Disregard of installation instructions.
- Damage due to faulty installation.
- Unauthorised product modifications.