Assembling The Turntable - Sony PS-LX350H Mode D'emploi

Getting Started

Assembling the Turntable

4
3
1
1
If your turntable is equipped with a voltage
selector, be sure to set the selector to your line
voltage.
2
Carefully, place the platter on the spindle.
3
Using the ribbon, loop the drive belt around the
motor pully. After looping the belt, do not forget
to remove the ribbon.
4
Place the rubber mat on the platter.
5
Slide the counter weight onto the shaft at the rear
of the tone arm and turn 3 or 4 times in the
direction of the arrow.
GB
4
7
2
5
6
110V·120V
220V·240V
6
Insert the headshell into the front of the tone arm.
Turn the locking collar in the direction of the
arrow until the headshell is secure.
7
Insert the hinges on the dust cover into the hinge
pockets on the rear of the cabinet.