Handling And Use; Switching The Appliance On/Off; Air Outlet Valve - SilverCrest SLE 320 D5 Mode D'emploi

Handling and use

This section provides you with important information on handling and using the
appliance.
Switching the appliance on/off
♦ Press the
You will hear a beep, and the
ously.
♦ Press the
You will hear a beep, and the
NOTE
► The appliance always starts up with the last-selected setting.
► If the appliance shuts down due to a power failure, it will automatically
restart with the last–selected setting when power is restored.
♦ If a timer has been programmed, the appliance switches off permanently
after the specified time has elapsed (1–24 hours).
♦ If the relative humidity value has been set in the TARGET HUMIDITY
program, the appliance switches off as soon as the value is reached. If the
value is exceeded, the appliance switches back on again.
♦ When the water tank 4 is full or removed, dehumidification stops. The fan
continues to run for approx. 3 minutes and then switches off. If the water
tank 4 has been removed or is not correctly inserted, the
LED p lights up. If switched on, the appliance will also beep for approx.
20 seconds.
NOTE
► The water tank 4 must be completely inserted into the appliance, other-
wise the condensation water cannot be properly collected.

Air outlet valve

■ 12 │ GB │ IE
STAND-BY button i to turn on the appliance.
OPERATION LED o lights up continu-
STAND-BY button i to turn off the appliance.
OPERATION LED o starts flashing.
On the top of the appliance there is an adjustable
flap 6 on the air outlet, which you must open during
operation. You can adjust the flap 6 to different angles
and thus determine the direction of the air flow. This can
be helpful if you are using the appliance to dry
washing, for example. In this way, you can direct the air
flow towards the wet laundry.
TANK FULL
SLE 320 D5