EINHELL EGS 3600 Mode D'emploi page 9

Output voltages /
max. current consumption:
Starting aid:
Power supply unit:
Mains voltage:
Output from power supply unit:
Nominal voltage:
Nominal current:
Nominal power:
Lamp
4. Charging the energy station with the
power supply unit
1. Set the ON/OFF switch (Figure 1 / Item 1) to
„CHA" position.
2. Plug the connecting cable of the supplied power
supply unit in the charging socket „CHARGE"
(Figure 1 / Item 7) on the unit.
3. Plug the power supply unit into a mains socket
outlet for 230 V( 50 Hz.
4. It takes around 24 hours to charge the energy
station.
5. The red LED (Figure 2 / Item 4) lights up in
charging mode and indicates that charging has
commenced. When charging is completed, i.e.
when the storage battery is fully charged, the
green LED (Figure 2 / Item 3) lights up as well.
6. Never use the supplied cigarette lighter cable to
charge the energy station.
5. Outputs
Output 12 V cigarette lighter socket. max 10 A.
¼
The 12 V output (Figure 1 / Item 2) can be loaded
with max. 10 A, i.e. you have max. 10 A at your
disposal.
¼
Check the power and power consumption values
of the consumer to ensure that you do not
overload the energy station. If you only know the
power data of the consumer you can calculate
the max. current very easily.
Example:
Consumer: 12 V / 50 W
The current consumption is 50 W / 12 V
= 4.17 A
12 V / 10 A via 1 cigarette
lighter socket
12 V / 600 A max. 5 sec.
230 V ~ 50 Hz
15 V
1000 mA
7.5 VA
12 V / 5 W
¼
Use the supplied connecting cable to link the
12V output socket with a suitable consumer
¼
Remove the caps to use the 12 V output and
connect the consumer.
¼
Then press the switch (Figure 1 / Item 1).
Operating hours of typical consumers
The appliances listed below are typical 12V
consumers. Their actual operating time depends on
the power consumption of the particular model and
the battery charge level.
Consumer Amperage
Halogen lamp
(HL 12-55,
Art. No. 10.955.00) 4.5 A
Car hammer
screwdriver 12 A
(KSS 12,
Art. No. 20.483.00)
Car compressor 7 A
Car vacuum
cleaner 7 A
TV with satellite
receiver 4 A
Cool-box 4 A
12V immersion
pump 4.5 A
Output 3 V / 6 V / 9 V; max. 1 A
¼
All three outputs together can be loaded with
max. 1 A, i.e. you have max. 1 A at your
disposal.
¼
The stabilisation of the 3 V, 6V and 9 V outputs
may be insufficient for certain electronic
appliances (video cameras, laptops, etc.). Please
consult the appliance's operating manual before
you connect it up. Pay special attention to any
information it contains about special accessories
(e.g. adapters for connecting video cameras to
12 V cigarette lighter sockets in cars, etc.).
GB
Provisional
uninterrupted
operation
4 h
1.5 h
2.5 h
2.5 h
4.5 h
4.5 h
4 h
9