HQ Power VDP575MHS16 Mode D'emploi page 5

CHANNEL 14
CHANNEL 15 SHUTTER, STROBE
CHANNEL 16 DIMMER AND RESET FUNCTIONS
c. DMX-512 Connections
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other side to the male 3-
pin XLR input of the VDP575MHS16. Multiple VDP575MHS16s can be linked through serial linking. The linking cable
should be two core, screened cable with XLR input and output connectors.
Please refer to the diagram at the right.
Caution: At the last fixture, the DMX cable has to be terminated with a terminator.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with the
fixture or one fixture with another.
Occupation of the XLR-connector:
How to turn the controller line from 3-pins into 5-pins (plug and socket):
d. DMX-512 Chain with termination
VDP575MHS16
ZOOM
A DMX terminator is recommended for installations where the DMX cable has to run a long
distance or is in an electrically noisy environment (e.g. discos). The terminator prevents
corruption of the digital control signal by electrical noise. The DMX terminator is simply an
XLR plug with a 120 resistor between pins 2 and 3, which is then plugged into the XLR
output socket of the last device in the chain.
Please see illustrations to the left.
0 255 Close / Open
0 19 Shutter
20 250 Strobe from slow / fast
251 255 Strobe effect from slow to fast
0 29 No Function
30 39 Lamp on after 3 seconds
40 59 No function
60 69 Lamp off after 3 seconds and reset
70 128 No function
129 255 Dimmer from 0 to 100%
5 VELLEMAN