Dometic Waeco PerfectView M9LQ Instructions De Montage Et De Service page 32

Installing the LCD monitor
7.2 Installing the monitor
!
CAUTION! Beware of injury
Select the location of the monitor so that it cannot injure the passengers in the
vehicle under any circumstances (e.g. sudden braking, road traffic accidents).
Observe the following installation instructions:
 Select an installation location that provides an unobstructed view of the monitor
(fig. 6 and fig. 7, page 4).
 Never install the monitor in areas where your head could hit it or in the airbag
deployment path. This could cause injury if the airbag opens.
 The monitor must not impair your vision when driving (fig. 8, page 5).
 The installation location should be flat.
 Check that there is sufficient space underneath the installation location to attach the
washers and nuts.
 Check beforehand that there is sufficient space on the other side for the drill head to
come out (fig. 2, page 4).
 Bear in mind the weight of the monitor. Provide reinforcement if necessary (larger
washers or plates).
 Make sure you can lay the connection cable to the monitor.
 If possible, use original ducts for laying the connection cable or other suitable options,
such as ventilation grilles. If there are no existing ducts, you must drill a hole of
∅ 17 mm. Check beforehand that there is sufficient space on the other side for the drill
head to emerge (fig. 2, page 4).
Choosing the installation location (fig. b, page 7)
➤ Set the monitor on the monitor bracket and secure it with the knurled nut.
➤ Position the monitor with the attached monitor bracket provisionally.
➤ Mark the outlines of the monitor bracket on the dashboard.
➤ Take the monitor off the monitor bracket.
32
PerfectView M9LQ
EN