Getting Started; Cancel The Demonstration; Set The Clock; Set The Basic Settings - JVC KW-R520M Manuel D'instructions

GETTING STARTED

1

Cancel the demonstration

When you turn on the power (or after you reset the unit), the display
shows: "CANCEL DEMO" "PRESS" "VOLUME KNOB"
1 Press the volume knob.
[YES] is selected for the initial setup.
2 Press the volume knob again.
"DEMO OFF" appears.
2

Set the clock

Press and hold .
1
Turn the volume knob to select [CLOCK], then press the knob.
2
Turn the volume knob to select [CLOCK SET], then press the knob.
3
Turn the volume knob to make the settings, then press the
4
knob.
Day Hour Minute
Turn the volume knob to select [24H/ 12H], then press the knob.
5
Turn the volume knob to select [12 HOUR] or [24 HOUR], then
6
press the knob.
Press to exit.
7
To return to the previous setting item, press
4
3

Set the basic settings

Press and hold
1
Turn the volume knob to select an item (see the following table), then
2
press the knob.
Repeat step
3
Press
4
To return to the previous setting item, press
SETTINGS
BEEP
SRC SELECT
AM *
AUX *
F/W UPDATE
SYSTEM
F/W xxxx
CLOCK
CLOCK SYNC
CLOCK DISP
ENGLISH
РУССКИЙ
ESPANOL
* Not displayed when the corresponding source is selected.
.
.
until the desired item is selected or activated.
2
to exit.
ON: Activates the keypress tone. ; OFF: Deactivates.
ON: Enables AM in source selection. ; OFF: Disables.
BT ADAPTER: Selects when the KS-BTA100 Bluetooth adapter is connected to the
AUX jack. ( 8) ; ON: Enables AUX in source selection. ; OFF: Disables.
YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not activated).
For details on how to update the firmware, see: <http://www.jvc.net/cs/car/>.
AUTO: The clock time is automatically set using the Clock Time (CT) data in FM
Radio Data System signal. ; OFF: Cancels.
ON: The clock time is shown on the display even when the unit is turned off. ;
OFF: Cancels.
Select the display language for menu and music information if applicable.
By default, ENGLISH is selected.
.
Default: XX