Télécharger Imprimer la page

Tenovis HSG-BASISMODUL DECT Notice D'utilisation page 25

Publicité

Les langues disponibles

Les langues disponibles

UK
DISABLING THE REMOTE PACK RINGER
Note: This feature is only available for headsets operating on AEI
If you do not wish the remote pack buzzer to ring to alert you to an incoming call, then the ringer
can be disabled by switching the Ringer Switch (23) to the Off position (position 0). The default
position is On (position I).
OUT OF RANGE WARNING
The Out of Range Indicator (14) will blink when the remote unit gets close to the range limit.
When this occurs you should walk back towards the base unit until the Out of Range Indicator (14)
stops blinking. If you walk away from the base unit you will eventually exceed the maximum
operating range for the HSG-Basismodul DECT Adapter. Any active call will be suspended and a
double beep will sound in your headset every 10 seconds to warn you that you are out of range.
The double beep will cease and the Out of Range Indicator (14) will extinguish once you return
within range and any active call will be taken off mute allowing you to resume your conversation.
Tip: It is strongly advised that you avoid walking out of range when on an active call as
you may find the call takes some time to re-establish after returning into range.
LOW BATTERY WARNING
When the remote pack battery is running low (approx. 5 minutes talk time remaining), an audible
warning will be heard through the headset as a single beep repeating every 10 seconds. Soon
after hearing this warning, you should recharge the remote pack, or change to a freshly charged
battery (if you have purchased the optional spare battery).
LISTENING TO AN EXTERNAL AUDIO DEVICE
The HSG-Basismodul DECT Adapter provides the option of using the headset to communicate with
one additional audio device apart from the telephone, e.g. a PC soundcard. This feature allows you
to use your headset with other audio devices. This additional audio source is referred to as External
Audio in the remainder of this guide. The External Audio Cable (41) must be connected between the
HSG-Basismodul DECT and the audio device via the External Audio Cable Port (33).
23

Publicité

loading