LENCO BTP-200 Mode D'emploi page 5

C. About the rechargeable Battery & Charging
This Bluetooth Speaker has an internal, non–user-replaceable battery. For
best results, the first time you use this Bluetooth Speaker, let it charge for
about 2 ~ 3 hours or until the "Charge LED (6)" light to off from On which
show you the battery is fully charged.
For maintain the battery life and performance, if speaker isn't used for a
while, the battery might need to be recharged. Charge the battery at least
once every month.
To recharge the built-in battery:
 Connect the Bluetooth Speaker's "Micro USB socket (2)" with the
Computer's USB port through USB cable.
 The "Charge LED (6)" light will turn On in red, the battery is in charging.
 The "Charge LED (6)" light will turn Off when the rechargeable battery
is fully charged.
 Disconnect the USB cable when it is done.
D. Power ON and Pairing
1. Press and hold "
will sound and the "Bluetooth LED (7)" will light and then fast blinking
blue in seconds.
2. Then activate the Bluetooth function in your mobile device (such as
Mobile Phone or Personal Computer), the device will enter to
Bluetooth searching mode automatically, if not, tap the relate selection
to manually enter to searching mode. (refer to your device's manual
when necessary)
3. Your mobile device should show
it for pairing. Waiting for some seconds and you will see connected
message as shown on your mobile device. (For some Bluetooth devices,
you may need to input "0000" as pairing password)
4. If pairing is successful, a series of tones will sound and the "Bluetooth
LED (7)" light will switch to slow blinking from fast.
5. Now, you can start to music play from the mobile device by it music
player program.
6. Press and hold "
use.
Note: for saving battery energy, the Bluetooth Speaker will turn to off mode
automatically when no device is in paired in 8 minutes. Turn On the device
by press and hold "
E. Disconnect from paired device
1. To disconnect with paired device, for better result turn Off the
Bluetooth Speaker directly.
(2)" button to turn On the device, a series of tones
"Lenco BTP200"
(2)" button to turn Off the device when it is not in
(2)" button to turn On the device if you want.
5
in list, and then select