Water Level; Refilling Water - Philips HU4816 Mode D'emploi

Note
• If no preset humidity level is selected,
the humidity indication light will be off.

Water level

When there is not enough water in the
water tank, the appliance will work in
the following ways.
•
The water level drops and the red
indicator light starts blinking
(fig. h).
•
The humidifier continues to work for
30 minutes and then stops working,
the red indicator light remains on.
The appliance will resume work when
you refill water into the water tank.
Note
• If the water tank is empty when the
humidifier is plugged in and switched
on, the red indicator light blinks for
2 minutes and then remains on before
the water tank is refilled with water.
• It is normal to find some water left in the
tank.
8 EN

Refilling water

Water level can be observed through
the transparent water tank window.
1
Switch off the humidifier and unplug
it.
2
Remove the upper unit by holding it
at both sides (fig. b).
3
Fill the water tank with cold tap
water until water reaches the
maximum water indication level
(fig. f).
Note
• When filling water, do not exceed the
maximum water level, or water might
leak from the air inlets.
• Do not shake the water tank when
moving it, or water might leak from the
air inlets.
• Do not fill water through the air outlets
on top of the humidifier.
4
Place the upper unit back onto the
water tank (fig. g).