Kenwood CMOS-320 Mode D'emploi page 9

Camera Setting (CMOS-320 only)
Switch Unit Operation
The switch unit can be used to switch the image display
mode, view/hide the guideline display and adjust the
camera.
View button
• Switches the image display mode.
• Select an item in the setting mode.
• Press and hold to display or hide the guidelines.
+/− button
Moves across the setting mode
items or sets an adjustment value.
Preparation Before Camera Setting
When the camera is installed as a rearview
camera:
1
Stop the vehicle.
In a parking space with white lines and tire stoppers, park the
vehicle in the center of the white line frame.
2
Advance the vehicle.
• Move the vehicle forward until the entire parking space can
be viewed in the camera image.
• Be sure to apply the parking brake and push the brake
pedal so that the vehicle is completely stationary. Perform
the setting in a place that will not cause nuisance to other
people.
When installing the front camera at a height of
50cm (1.64 feet) or more:
Prepare as same as the rearview camera.
When installing the front camera below 50cm in
height:
1
Install the camera at the center of the vehicle
(page 4).
• If not, the image may not be symmetric in the "Corner
View".
2
Move the vehicle on the center of the parking
line.
• You can use a long stick instead of the parking line if you
can not use the 2 parking lots etc.
• Be sure to apply the parking brake and push the brake
pedal so that the vehicle is completely stationary. Perform
the setting in a place that will not cause nuisance to other
people.
3
Set the camera.
Adjust the "Overhead View Image Adjustment" (page 10, 11)
so that the parking line is displayed vertically in the center.
9
|
CMOS-320/CMOS-220