Kenwood CMOS-320 Mode D'emploi page 8

System Connection (CMOS-320 only)
• W hen connecting the camera to a Kenwood navigation system etc, (Control unit) equipped with the camera control function, use
the provided control unit connection cord. This allows the control unit to switch the display view and adjust the camera as well
on touch the control unit screen.
• W hen using two CMOS-320 units (for the front and rear), it is required to set an ID for the front camera. For details, see "Camera
ID Setting" (page 13).
• C onnect the power supply in the same way as "Basic Connections".
• The provided switch unit is not used in the system connection.
Connection of 2 Cameras
Connect to the dedicated rearview camera video
input.
Camera 1 (Used as rearview camera)
Connect to the camera
control terminals of the
control unit.
Camera 2 (Used as front view camera)
Connect to the external video input. Select the
external video input to check the camera image.
8
|
CMOS-320/CMOS-220
CAM+ (Green/red)
CAM- (Green/white)
Video cord
Power cord
Power cord
Video cord
To power supply