Kenwood CMOS-320 Mode D'emploi page 6

Installation
12
Fix the camera firmly in position.
Peel off the paper liner from the double-side adhesive tape
on the camera bracket and attach it. After attaching, push the
camera bracket with your finger to ensure close adhesion.
Do not touch the adhesive surface with your hand or peel and
reattach an attached tape, as these will degrade the adhesive
force and may cause the camera bracket to be detached. If
required, secure the bracket on the vehicle body using the
camera bracket clamping screw.
The camera bracket has two holes for the screw. Select one of
them to fit the position of the attachment.
6
|
CMOS-320/CMOS-220
Camera bracket clamping screw
(M3 x 8mm)
Installing the Switch Unit
(CMOS-320 only)
1
Clean the switch unit installation surface.
Using a commercially available cleaner, wipe dirt, moisture
and oil away from the surface on which the switch unit is to
be attached.
2
Attach double-side adhesive tape on the
bottom of the switch unit and then attach it in
an easy-to-operate position, for example near
the dashboard on the driver seat side.
When using the camera as a front camera and with a
Kenwood navigation system, this switch unit is used only for
the ID setting of the CMOS-320 unit. So you do not have to
attach the switch unit with double-side adhesive tape. For
the ID setting, see "Camera ID Setting"(page 13)