Kenwood CMOS-320 Mode D'emploi page 10

Camera Setting (CMOS-320 only)
Camera Setting Procedure
1
Complete all of the required connections in
advance.
2
Display the camera video.
For displaying the camera video, read the instruction manual
for your video monitor.
3
Press and hold the view and + buttons of the
switch unit simultaneously to enter the camera
adjustment mode.
4
First select the positioning of the camera.
Use the + or – button to select an item and press the view
button to enter the selection.
• When using the camera as the rearview camera, select
[OK]. And then go to step 6.
• When using the camera as the front camera, select
[Normal] and then select [OK]. And then go to step 5.
• Selecting [Reset All] resets all of the camera settings
to the defaults.
5
Adjust the camera's mounting position with
the + or – buttons on the switch unit.
Select [Standard] when installing the camera at a height of
50cm to 80cm (1.64feet to 2.62feet).
10
|
CMOS-320/CMOS-220
Select [Lower] when installing the camera at a height of
30cm to below 50cm (0.98feet to below 1.64feet).
6
Select a camera adjustment item and adjust it.
The following items are available for camera adjustment.
1. Overhead view image adjustments
(Centering, Right-and-Left angle, Up-and-Down Angle)
2. Wide view guideline adjustments
(Size, Horizontal direction, Red Line Position Setting)
To select an item:
Press the + or – button to select an item and press the view
button to enter the selection. When an adjustment item is
selected, the frame of its icon turns from blue to yellow.
To adjust the item:
After selecting the item, press the + or – button to adjust it
and press the view button to enter the adjusted value.
7
End the setting.
Overhead View Image Adjustment
(Centering)
This item adjusts the center of the camera installation
position.
1
Select "OVERHEAD VIEW IMAGE ADJUSTMENT
(CENTERING)".
2
Press the + or – button of the switch unit so
that the two white lines appear on the position
corresponding to the center line of the vehicle.
Adjustment is possible by two steps to the left and right.
If the adjustment is not possible in the currently available
range, change the camera position before retry.
• Select [Back] to go back to the previous adjustment
item.
• Select [Next] to advance to the next adjustment item.
• Selecting [Reset] in an individual adjustment item
resets the camera setting of that item to the default.