Native Technology B-TWIG12PRO Notice D'emploi page 4

3 CH1 / CH2 - EQUALIZER
This two-band equalizer allows you to boost or cut the high and/or low frequencies, to
achieve the desired sound.
4 CH1 / CH2 / LINE/TAPE IN - LEVEL
These knobs adjust the volume of the corresponding channel, turn them to the right to
raise the level, to the left to decrease it.
5 MAIN SECTION - TWO-TONE SIG/CLIP LED
Green: the signal is present in the MAIN channel.
Red: the input signal to the MAIN is very strong and is close to distortion.
If the LED is steadily lit, you must reduce the MAIN LEVEL level or adjust differently level
of CH1 / CH2 / LINE/TAPE IN and AUX.
6 ON
The LED is lit when the unit is connected to the mains and the switch is set to ON.
7 MAIN LEVEL
This control adjusts the overall output volume of the system. Turn the knob clockwise
to increase the volume or counter-clockwise to lower it.
8 SUB LEVEL
This control adjusts the output volume of the subwoofer and allows you to balance
the level of lower frequencies, based on environment acoustic response. Turn the knob
clockwise to increase the SUB volume or counterclockwise to lower it.
9 STEREO / MONO BUTTON
It allows to select the system listening configuration in two operating modes: STEREO
or MONO.
- Set the button to MONO when using a single B-TWIG 12 PRO system; in this case all
the stereo signals of the inputs are internally summed. You can connect an additional
unit via the MIX OUT MONO (L/R) output, thus duplicating the sound front.
- Set the button to STEREO when using two B-TWIG 12 PRO systems; in this case all
the stereo signals of the inputs are mixed in LEFT / RIGHT and simultaneously managed
with the respective systems as follows:
the left channel (L) of all stereo inputs is reproduced by the main unit, while the right
channel (R) of all stereo inputs is reproduced by the additional unit connected to the
MIX OUT STEREO (R) output.
10 PAIR - BUTTON & LED
Use this button to synchronize the Bluetooth
following procedure:
• press the PAIR button for about 3 seconds until when the LED rhythmically flashes;
• to start synch, activate Bluetooth
®
• in your smartphone or tablet list of devices detected, select "B-TWIG 12 PRO" to
synchronize your mobile device with the system.
B-TWIG 12 PRO
6 User manual |
device with the system applying the
®
from the user interface of your mobile device;
At the end of the operation the LED is steadily lit and the tracks can be
played back, as long as device maximum distance from the unit does not
exceed 10 meters.
The Bluetooth connection can be deactivated at any time by holding down
®
the PAIR button for 3 seconds or by desyncing the B-TWIG 12 PRO unit from
the mobile device. In both cases, the indicator light flashes slowly every 5
seconds, indicating that the connection has been deactivated.
11 AUX IN STEREO
This 3.5mm stereo input accepts the cable signal from external devices, such
as a smartphone, tablet, PC or any other device with a stereo mini-jack output.
10
11
12
13
14
15
B-TWIG 12 PRO
7
| User manual