Troubleshooting; Technical Specifications; User Manual - Section - Native Technology B-TWIG12PRO Notice D'emploi

6 | TROUBLESHOOTING

PROBLEM LED
Power LED
turned off.
No sound or very low
sound level
Power LED
turned on, but low
MAIN LEVEL.
SIG/CLIP LED lit red
Distortion ON/LIMIT LED
lit green
Booming sound
Harsh sound
Attenuation of some
frequencies that are
predominant, not very
faithful signal, reverberating
environment
B-TWIG 12 PRO
20 User manual |
SOLUTION
Make sure the system is
properly connected to the
mains outlet.
Raise MAIN LEVEL knob.
Lower inputs and/or
MAIN LEVEL knob.
Check the source level
Check proper connection
between subwoofer and A/B
speaker elements
Lower SUB level
Raise SUB level
Lower MAIN LEVEL knob.
Try choosing a different
preset, minding also the
acoustic characteristics of the
environment.

7 | TECHNICAL SPECIFICATIONS

System type Active column system
Vented enclosure
Subwoofer (B-TWIG 12S PRO)
1 x 12" Ferrite - 2.5" VC - custom speaker
12 x 3.5" - 1" VC - neodymium custom
Column speaker (B-TWIG 12CS PRO)
speakers
Average dispersion 120°
Frequency response 45Hz - 20kHz
MAX SPL 126 dB
Amplification Class D
Peak power (LF + HF) 2800 W
Crossover 24dB/Oct @ 200Hz
DSP 56Bit
AD/DA conversion 24Bit / 48kHz
System EQ 4 presets
CH1 & CH2: 2 x XLR-F + 2 x 6,35mm
(1/4") jack
CH 3 LINE IN: 2 x combo L/R
TAPE IN: RCA L/R
I/O connectors
AUX IN: 1 x 3.5mm mini-jack
SUB OUT/MIX OUT: 2 x XLR-M
DFX FOOTWSWITCH: 1 x 6,35mm (1/4")
jack
Power supply 220-240V~ 50-60Hz
Fuse T4A L 250V~
Power consumption 700 W
Connector with automatic coupling and
Fastening mechanism circular connection
Speaker rotation - 90 degrees left/right
B-TWIG 12 PRO
21
| User manual